Vertical GMC models, tested and chosen for over 40 years, are specially designed for customers who demand many cuts per minute. This design has doubled the number of strokes in comparison to the hydraulic model for cutting sheets ranging from 1.2 mm to 5 mm in thickness. It has a crosshead guided by fixed tempered gibbings which ensure a fast and accurate cut protecting any deformation. The blades of the upper and lower crosshead have four cutting edges useful for cutting. The solid grooved working table and the three workpiece supports facilitate the handling of the workpiece. The simple and low-maintenance drive gear has a flywheel and drive box mounted on high-quality rollers. This is the key to achieve many strokes per minute.
HYDRAULIC GUILLOTINE SHEAR – 20 STROKES PER MINUTE.
MECHANIC GUILLOTINE SHEAR – 44 STROKES PER MINUTE.

Table type solid machined and slotted plate with three carriers to allow for rapid movement of the piece to be cut.

Press plate system, sturdy and robust and the perfect fit without any mark sheet.

Backgauge manual sliding type zipper graduates and pulley movement.

Backstop equipped with recirculating balls screws and guides rectified.
The folding top (optional) allows the passage of sheets of indefinite length.

The CNC control, designed, produced and guaranteed by our group of highly qualified engineers, offering programming of 63 programs of 10 lines each, with 999 cuts.

• Movement has manual: You can move the stop in this way of working with two Keys and increase or decrease the speed with two others. The tour ends They are protected with safety to careers that inhibit movement. Automatic movement
• : This working mode allows you to upload a coat on the display and The top will move only to that elevation. Movement
• work programs: This mode allows 63 programs of 8 Lines each with 999 sections and stored in memory with different numbers.
• The machine does not need to be referenced, when I turn on the display load the benchmark That was when it was disconnected.
• has protection for when the top court is moving to not run Unwanted movements.
• has a data input key for a possible calibration of the same in which You can load a coat in a certain position.
• programming has alphanumeric display with back light LCD. In this Display may see flaws that can have the machine as an inconvenience In the speed governor or a micro end of travel, and so on.
• has a numeric display of 21 mm. high reading of the benchmark, which can be Expressed in hundredths of mm or tenths of a key election.
• key panel textured polycarbonate armored wing entrance of dirt and dust.

• 1 rule of squaring. .
• 3 pins of front plates. Finger Protector
• . Foot Control
• mobile.

• CNC backstop.
• recirculating ball screws.
• squaring arm and supports greater length. Foot Control
• mobile.