Vertical GHC V CNC models are specially designed for cutting sheets that range between 1.2mm and 5mm in thickness. They have a crosshead guided by fixed tempered gibbings which ensure a fast and accurate cut with no deformation. The blades of the upper and lower crosshead have four cutting edges which are useful for cutting. The solid grooved working table and the three workpiece supports facilitate the handling of the sheet. Compact and easy-to-maintain hydraulic equipment placed under the working table.

Table type solid machined and slotted plate with three carriers to allow for rapid movement of the piece to be cut.

Press plate system, sturdy and robust and the perfect fit without any mark sheet.

Cap type manual sliding rear zippered graduates and pulley movement.

Backstop equipped with recirculating balls screws and guides rectified.

The CNC control, designed, produced and guaranteed by our group of highly qualified engineers, offering programming of 63 programs of 10 lines each, with 999 cuts.

• Movement has manual: You can move the stop in this way of working with two keys and increase or decrease the speed with two others. The tour ends they are protected with safety to careers that inhibit movement.
• Automatic movement: This working mode allows you to upload a coat on the display and the top will move only to that elevation.
• Movement work programs: This mode allows 63 programs of 8 lines each with 999 sections and stored in memory with different numbers.
• The machine does not need to be referenced, when I turn on the display load the benchmark that was when it was disconnected.
• It has protection for when the top court is moving to not run unwanted movements.
• It has a data input key for a possible calibration of the same in which a dimension can be loaded in a certain position.
• Programming has alphanumeric display with back light LCD. This display will be able to observe flaws that can have the machine as a disadvantage in speed regulator or a micro end of travel, etc..
• It has a numeric display of 21 mm. high reading of the benchmark, which can be expressed in hundredths of mm or tenths of a key election.
• Key Panel textured polycarbonate armored wing entrance of dirt and dust.

• 1 rule of squaring.
• 3 front plate brackets.
• finger protector.
• Mobile Control Pedal.
• Top zippered rear manual

• CNC backstop.
• recirculating ball screws.
• squaring arm and supports greater length.